Hi Joe, Thanks for the observation. Yes, I now confirm that if I'm operating CW with the CWT function turned ON and then switch to another band (which was previously left in CW mode) then the CWT will remain ON. However, if the band I switched to is any other mode then CW then the CWT function is turned OFF. So it looks like half the request I asked for is already implemented! Now all that is needed is to change the firmware to leave the CWT function in whatever state I left it in prior to changing from CW to any other mode.
Thanks for your input Joe, Frank - W6NEK ----- Original Message ----- From: "Joe Planisky" <jp...@jeffnet.org> To: "Ken Kopp" <k...@rfwave.net> Cc: "W6NEK" <w6...@socal.rr.com> Sent: Tuesday, January 20, 2009 6:50 PM Subject: Re: [Elecraft] K3 - CWT ON/OFF change request > Hey Ken & Frank, > > Hmmmm. On my K3 (running firmware 2.78), the CWT stays on when switching > bands. It does turn off if I change modes, but it seems like the band > change part of your request has already been granted. > > If you're not running the latest firmware, this might be a good excuse to > upgrade :-) > > 73 > -- > Joe KB8AP > > On Jan 20, 2009, at 6:18 PM, Ken Kopp wrote: > >> Yes, Yes ... me too! >> >> I too, would appreciate this addition. I thought I might >> be the only one who noticed this "omission". Turning >> on "CWT " is the first thing I do after landing on a band. >> >> I'm a CW-only type and I never operate without it ... or >> "SPLIT" mode, for that matter. It could remain on all >> the time "CW" is the chosen mode. >> >> 73! Ken Kopp - K0PP >> elecraftcov...@rfwave.net _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
