James: There can be a 'cumulative' fit error sometimes.
When I assemble a new K3, I leave all of the screws which attach to the 2D connectors (incl. those going thru the RF board holes), slightly loose until I do the final 'snugging' of everything somewhere toward the end of the main assembly process. This usually helps to minimize any possibility of cumulative fit errors. If you have your K3 all built, try loosening all of the EXTERIOR screws which go into a 2D connector, and then retighten them. Good luck, Tom Hammond N0SS At 20:25 03/04/2009, you wrote: >Dear group, > > > >While I have all panels securely mounted to the point that I don't have any >major issues, I have noted that my top and rear panel alignment has been >slightly off. This is in the sense that when securing those particular >panels down, the screw holes don't align themselves with the holes drilled >in those particular panels. Has anyone else noted such an anomaly, and if >so what was the remedy? Now that I have the rig working as expected, I >figured I'd just loosen the 2D fasteners on the main board enough to get the >holes in the rear and top panels aligned up correctly. > > > >73, > >James KC2UEE (soon to be K3JPS) > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Elecraft@mailman.qth.net > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html