Dan, In this particular case, a little high is not a problem - low might be problematic. Normally if a single value is listed for a resistance check, allow a +/- 10% tolerance, but when a range is listed, normally the readings you obtain should fall within the listed range.
73, Don W3FPR > and am performing the resistance checks as recommended in the manual. All > check out OK except for the test for pins 29 and 30 of U6 (the dash and > dot/ptt pins). The resistance values as stated in the manual are 70-90 > kohms. I'm reading 96 kohms on both pins. Do I have a problem? My DMM is > an inexpensive one, so is the 7% deviation to be expected (within > tolerances). If this is bad, any ideas on what to check? Thanks, > > Dan Kreithen > AE3E > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html