Ron, others ... If the holes in the knobs were tapped with a "normal" (tapered) tap, the threaded hole will be of slightly less diameter near the "bottom" (shaft) end of the hole. This would tend to increase the likelihood of forcing the knob to split. There isn't enough room for a tapered tap to go far enough through the set-screw hole to produce a straight thread. A "bottom" tap produces a straight-sided hole even when there's not room for full travel of a tapered tap..
Not that any of this would be useful information unless one was installing a replacement knob and used a bottom tap before installing. One poster suggested using controls with shafts with flats and push-on knobs. Unless care is used or the depth of the hole in the knob and the length of the control shaft is carefully controlled, the knob is likely to end up rubbing the panel and creating rings of worn-away paint. 73! Ken Kopp - K0PP elecraftcov...@rfwave.net http://tinyurl.com/7lm3m5 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html