Please don't do firmware upgrades through the microHAM router. You may sometimes succeed if you tell the router that the radio type is "none".
Please don't start this unless you have an alternate USB to Serial adapter or an RS-232 connection available. The K3 Utility doesn't see responses to a K3 in "boot load" state when it's connected through a microHAM router. Dick, K6KR -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of John Gaynard Sent: Tuesday, October 20, 2009 7:21 PM To: elecraft@mailman.qth.net Subject: [Elecraft] K3 firmware upgrade via Microham MKII Can the Microham MKII be used to do the K3 Firmware upgrade. I know it was possible but after the loader was originally upgraded there was a possible glitch that would cause the firmware load to fail. My firmware is at 2.38 and I think it is time to come out of the Dark Ages once again. John K8WDN K3 #157 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html