2. Click on the Command Tester/K3 Macros tab. This is incorrect. Use #3 below. It's a menu item, and brings up a separate screen.
3. Click on the Edit Macros button at the top of the screen. This brings up the macro edit window. It's Edit, then choose Command Tester/K3 Macros.. 73, Mike NF4L Paul wrote: > I'm following the instructions in the programmer's guide, but my screens > don't match up with the manual. > I have the latest version of the K3 utility, ends in "30". > > Here's the problems: > > To create this macro and assign it to a K3 front panel switch, you'll > need to complete all of steps 1-8 below. Once you've been through the process > one time, you'll find creating or > modifying macros very easy. > 1. Run K3 Utility. > 2. Click on the Command Tester/K3 Macros tab. <==== no K3 Macros tab, just > "Command Tester" > 3. Click on the Edit Macros button at the top of the screen. This brings > up the macro edit window. > 4. In MACRO 1's Macro Label field, enter the label "SPLIT+2". > 5. In the Macro Commands field, enter: > SWT13;SWT13;FT1;UPB5;RT0;XT0; > Note: The number 5 in the "UPB5" command is not a value in kHz; it is an > index into a table of step sizes. UPB5 > moves VFO B up 2 kHz, DNB5 moves it down 2 kHz, etc. (there are similar > commands for VFO A). For the full list of UP/DN command variations, see the > DN (down) command (page 7). > 6. Click on Send Macros 1-8 to K3. Exit the edit window by clicking <======= > no such "Send Macros 1-8 to K3" > Save. <======= clicked on SAVE > <<<<<==== the K3 goes into SPLIT when I click on the Macro button in the > config util, but VFOB doesn't change at all..... > Never got past this point. > > > .....within the Command Tester by clicking on its associated button. (The > label won't flash on VFO B when this is > done from K3 Utility - only when using the assigned switch at the K3.) > 7. At the K3, locate CONFIG:MACRO x menu entry. Tap '1' if the menu > entry label is not already "MACRO 1". > 8. Hold PF1 to assign PF1 to MACRO 1. Exit the menu. > From then on, using PF1 will flash SPLIT+2 and execute the above sequence > > Anyone have any advice? > > Thanks > Paul > WY7I > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html