Thank you, Doug, that gave me all the info I needed. I have the BNC-connector installed, so I will leave it for later, just in case... Thank you and 73s de Franz, DK1ii
----- Ursprüngliche Mail ---- > Von: Doug Joyce <d_jo...@sympatico.ca> > An: Franz Nieberding <dk...@yahoo.com> > Gesendet: Donnerstag, den 29. Oktober 2009, 1:37:16 Uhr > Betreff: Re: [Elecraft] TMp Cable and Allen Wrench Envelope > > Franz: You didn't indicate whether or not you have the KRX3 subreceiver > installed in your K3. If you do there are two ways to connect the KRX3 to > an antenna. Ref the "Main and SubReceiver Antenna Routing" section in the > K3 Owner's Manual (pg 40 - 42 in my Rev D1 version). > > If the "spare" TMP cable is 12" long then it is likely to be used for an > optional setup for the KRX3 Antenna Input. Ref the "Auxiliary KRX3 Antenna > Input (Optional)" section of the KRX3 Installation and Operation Manual, pg > 24 in my Rev C version). The "spare" 12" TMP cable is used to connect the > KRX3 to its antenna via the KAT3 Antenna Tuner. Ref the "Installing KRX3 > AUX RF (ANT) Connector" section in the K3 Assembly Manual (pg 19 in my Rev > F version). The 12" TMP cable is not used if the KRX3 AUX RF (ANT) BNC > Connector has been installed, but is included in the kit if you wish to > change the wiring configuration later. > > As to the Allen keys - there should be two supplied with the kit. The large > one is for the set screws on the two main VFO knobs (A & B), the smaller one > is for the set screw on all the other smaller knobs. > > Hope that helps and enjoy your new K3. > > 73 Doug, VE3MV > K3/100 s/n 2432 > > > ----- Original Message ----- > From: "Franz Nieberding" > To: > Sent: Wednesday, October 28, 2009 4:55 PM > Subject: [Elecraft] TMp Cable and Allen Wrench Envelope > > > > Hi all, > > I am a proud new owner of a K3, which was handcarried by a friend to > Europe. After a week or so he sent me two little envelopes, one with a TMP > cable, one with a Allen wrench. I couldn't find a hint what to do with these > little parts, are they a sparepart/tool for just in case or did I miss > something and they are needed to bring the nice new toy up to speed? Maybe > somebody can tell me, please. > > 73s de Franz, DK1II > > S/N 3535 > > > > > > > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:Elecraft@mailman.qth.net > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html