Lyle Johnson wrote: >> I downloaded 3.63 and installed it. Following a seemingly successful >> installation, pressing the "ANT" button to change antennas generates an >> error message: >> >> "No ATU" >> >> "ATU TUNE" gives the same message. > > Go to CONFIG:KAT3 and be sure it is on. If it says "not inst" then it > may have somehow gotten switched off.
Thanks, Kyle. It is set to "Auto". But this was after reloading the stored, older configuration. So perhaps it was reset to "Not inst" after loading the new firmware, but why would loading the new firmware cause such a change? 73, Bill/NG3K ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
