Yesterday I overcame my fears :-) and successfully performed the following mods on my K3 (S/N 1672):
K3 AF Mod (Line out & speaker) IF Output Buffer Gain Mod K3 Extreme Signal RX Protection Mod But, I was not able to perform the K3 AF Output Mod (two 470 ohm resistors on the KIO3 board). I found it impossible to hold the resistor in place will soldering to the connector pins. Does anyone have any suggestions on techniques for installing these resistors? Steve N9SZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html