Well I figured out my problem (operator error). The ATU was in Calibrate mode and not Tune mode. So it is working now. However, when I try to tune 30m the power jumps straight to 6.3W (!) and doesn't fluctuate like the power reading does on other bands (40m jumps from around 4.6-5.1 watts with a 12v supply) Not to mention that the ATU gives me a somewhat poor SWR (1:2.8) on 30m even when it used to match relatively well (<1:2). I don't currently use 30m so it's not a big deal to me but something doesn't seem right...?
Luke <>< KD0FIN KD0FIN wrote: > > So I just installed the KXB3080 and completed the 2 resistor "power mod" > but now my ATU doesn't seem to be working. It gives me power and SWR > reading when I use the "tune" function but I don't hear the relays > clicking and it isn't matching anything anymore. It might be unrelated but > also it seems to be very hard to find signals as well. I could hear a > couple faint ones on 80m but everything else seemed dead. The radio was > working as normally as I could tell after installing the KXB3080, and I > don't think I could have screwed up the the 2 resistors enough to cause > any problems? > -- View this message in context: http://n2.nabble.com/KX1-ATU-problem-tp4149575p4152762.html Sent from the [KX1] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html