On Sun, Dec 27, 2009 at 11:26 PM, Richard Thorpe <kis...@earthlink.net> wrote: > I have my sub receiver connected to a "receive only" antenna through the BNC > connector on the K3 rear, the coax from the BNC goes to the second receiver > board. I assume this is the only way a signal can get to the sub receiver? a > signal cannot be routed via the ATU to the sub receive board?
Not true, but it requires hardware reconfiguration. See the KRX3 manual, page 24: http://www.elecraft.com/manual/KRX3_Subreceiver_Install_and_Operate_Rev%20D.pdf Also see the section on antenna routing in the K3 manual. ~Iain / N6ML ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html