Hello friends, I tried to look for below mentioned function (jumper settings) in 144MHz module but in last rev of manual I missed or it is not there. (yet?)
Are there any details about this possibility - to put +TX to centre pin of BNC output? Thanks for info, 73! Lexa, ok1dst K3/10 #727 Dne 19.8.2009 23:20, Eric Swartz - WA6HHQ, Elecraft napsal(a): > There is a jumper block that optionally allows the connection of a +5V > signal onto the antenna connector during transmit. A maximum of 1 ma. > is available. > > 73, eric WA6HHQ > > Alexandr Kobranov wrote: >> Let me ask - was +TX signal (9-12V) on centre pin of BNC included in >> future plan? >> This "option" (one internal jumper at least) is very practical for >> most of (in EU :-)) used transverter system control during FD etc. >> >> And thanks for all so big job with Kx, Px, ... development!! >> >> 73! >> Lexa, ok1dst >> K3/10 #727 >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html