Stan W5EWA asked: > I've noticed that I am unable to operate the NR & NTCH independantly > on the main & sub receiver. If I turn either control on, it's on for both > receivers. Can't turn it on for one receiver and have it off for the other > like you can for the Preamp & the NB. I installed the 2nd DSP for the Sub > receiver. Why doesn't it have it's own NR & Notch?
Stan, I believe this is a limitation of the current firmware. When band independence of the sub receiver was added back at ver. MCU 3.03 / DSP 2.10, 3-17-2009, it was said that this would be so (for now). The firware release notes stated that some of these limitations would be lifted in future releases: New Feature: Band Independence for the Sub Receiver * MAIN/SUB RECEIVER BAND INDEPENDENCE. If CONFIG:VFO IND is set to YES, then VFO A and B can be set to different bands. In this case BAND UP/BAND DN will only move VFO A, but in BSET mode, they will apply to VFO B. VFO B can also have a different mode from VFO A. Some RX parameters can be set differently for the sub receiver when in BSET mode, including PRE, ATTN, all DSP controls, and NB (noise blanker) settings. Limitations: For now, NR, notch, and some other controls remain common to both receivers. Internal text decode (CW, FSK-D, PSK-D) is available only for the main receiver. Scanning still must be set up using both VFO A and B on the same band. Memory recall only updates VFO A if VFO B is on a different band. (Most restrictions will be removed in future revisions.) 73, Bruce N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html