I have been corresponding recently with Dick Dievendorff about this. I am looking into allowing K3 Utility to work through LP-Bridge. The issue has to do with K3 Utility needing to be able to change one of the meta commands in the K3, which is normally blocked by LP-Bridge to prevent multiple applications from independently changing meta commands which might conflict with other apps.
If I do this, it will add a check box for the VPort where K3 Utility is connected, and I would still strongly recommend that flashing of new firmware NOT be done through LP-Bridge. 73, Larry N8LP Date: Thu, 18 Feb 2010 11:01:57 -0800 (PST) From: Bob - W0GI <b...@gotoloveland.com> Subject: [Elecraft] K3 Utility and LP-Bridge - Correction To: elecraft@mailman.qth.net Message-ID: <1266519717347-4593636.p...@n2.nabble.com> Content-Type: text/plain; charset=us-ascii While setting up LP-Bridge, I assumed the the K3 Utility would work ok as "Test Communications" worked ok, and the firmware page was showing my versions. But I have found other functions do no work. Looking at the LP-Bridge page I found this. "Some commands are intenionally blocked altogether. For this reason, the K3 Utility should not be used with LP-Bridge." Mommy always told me to read the manual first. :>) That said, my previous posts on using K3Util with LP-Bridge are incorrect. -- ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html