Last month some might remember that I posted a plea for help in fault finding my K3 RS232 connection.
The fault was traced to an "open" RFC L3 on the KIO3 digital I/O board. Bridging this RFC with a piece of resistor wire brought the RS232 connection back to life. A replacement L3 is on its way. Many thanks to Gary Surrency for his help in solving this problem, W3FPR and many others who gave lots of helpful suggestions. As always, great support from the Elecraft family! 73 Roger MW0IDX PS who is patiently waiting for his first amp to be an Elecraft model, 400~600w would be just fine ;-) K3 #191 K2 #2724 KX1 #416 ------------------------------------------------------------------------ Hi all, I can't work out why my K3 has stopped communicating with my PC. Besides the K3 utility I'm using HRD. Up to now I've used the KUSB which has worked fine, it was bought with K3 #191 at the same time. I reinstalled the drivers checked Baud rate (38400), swapped ports etc but still no go. I then tried a standard RS232 instead, but still it does not work. What am I missing here? Any help would be appreciated (my email is set to digest mode). 73 Roger MW0IDX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
