Hi Bill: I think that problem occurs if you turn off the K3 before quitting the Utility program. It's the quitting of the Utility program that initializes the sequence to return the baud rate that you previously had the K3 set to. It can't do it if the K3 is off.
73, Mike K2MK > FYI > > Just in case someone else has this same problem, I loaded the latest K3 > firmware onto my rig and when the load was complete I found that my K3 > would no > longer control the Palstar tuner. > > It seems that the K3 Utility does not return the RS-232 port back to the > original baud speed setting that was used before the down load when it is > finished. After I reset the RS-232 port speed back to the original 9600 > setting then the Palstar tuner started tracking again. > > 73, > Bill - K6WLM > KX1, K2, K3-100k ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html