I've seen this posted before, but just noticed it tonight, the first time I've operated the rig on the air since I fixed an intermittent last Saturday. I also just installed version 3.94. The posts I've seen before talked about SSB, but . . . .
If I adjust the power control to the power I wish to transmit, when I first transmit the power starts out low but finally creeps up to the correct power output. If I watch the power meter (LP-100A), and even the power meter on the rig, if I have changed the power control going from say 15 watts to 100 watts, the first dits or dahs are at varying but constantly increasing power increments until it reaches its final resting place. It only takes a couple of seconds, if that. Once there, it stays put. Obviously better than a high initial power spike, but nonetheless it shouldn't be. Anyone else see this or am I the unfortunate one with this small issue? 73, Dan -- N3ND ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html