Brian, There is no provision to trim the crystal frequency on the XG2. This signal generator is designed to produce a well controlled output level, but not a precise frequency reference. It *is* a frequency stable signal source, but the exact frequency depends on the particular crystal. If you want to move the frequency down a little bit, you could add some small NPO capacitors across the crystal leads. Experiment to determine the value needed. I guess one could install some surface mount trimmer capacitors on the bottom of the board, although the height of the feet might have to be increased to allow enough vertical space for the trimmers.
73, Don W3FPR Brian - N5BCN wrote: > Hello, > > I recently assembled a XG2 signal generator and was wondering if there is a > way to trim/adjust the output frequency. I also have a XG1 and it has a > trimmer pot to adjust the signal to a reference, the XG2 has no such > adjustment that I can tell. > > Thanks! > > N5BCN - Brian > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html