That's it!! I had forgotten about that menu setting. Works properly now. I can detect some low level crosstalk but I suspect less than the FT1kMP. Will check with some big sigs in WPX.
Thanks for all the responses. Chris G3SJJ Guy Olinger K2AV wrote: > Make sure you have that you don't have CONFIG: L--MIX--R set to > something other than "A b". Possibilities are A b, Ab b, A > Ab, Ab Ab. Also make sure that you have CONFIG: SUB AF set to "nor". > > Also it is possible to set L-MIX-R via programming over the serial > line from a program, so it could have been left in this state from > running a logger, etc. > > If those are correct, make sure you don't have a wiring error. The > headphone channels with the above settings are completely separate on > my K3. > > 73, Guy. > > On Wed, May 26, 2010 at 4:14 PM, Chris G3SJJ <g3...@btinternet.com> wrote: > >> I am trying to set up my K3 for FD here in Eu in 10 days time. I have >> successfully used SR2O in the past with FT1kMPs but so far not with the >> K3. I have a splitter box which takes both Rx audio channels from the >> headphone socket and splits to one headset for main rx and another with >> sub rx. Neither operator should hear the other rx. This works perfectly >> with the FT1kMP but so far I can't get it to work with the K3. Any >> suggestions? >> >> Chris G3SJJ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html