Hi Joe, Thanks for the link, do you know if Elecraft included this mod and when they may have started doing so, and if they did, how I can tell that my K3 has it?
With the age of this unit (#4249), I would prefer not to start modifying it just yet, at least not until the warranty expires. It's unfortunate for me that I wasn't aware of this short fall before purchasing what I was told was a good solution for the lack of a panoramic display on the K3. Thanks to you and Don for the information. 73 George...WA1NTA -----Original Message----- From: Joe Subich, W4TV [mailto:li...@subich.com] Sent: Saturday, June 05, 2010 10:10 PM To: WA1NTA; Elecraft Reflector Subject: Re: [Elecraft] SDR-IQ Unless you have performed the IF Output buffer gain modification <http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf> or use the Clifton Labs broadband buffer amplifier between K3 & SDR-IQ <http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf> what you see is entirely normal. The unmodified K3 IF output is approximately 17 dB lower than the RF signal input level. 73, ... Joe, W4TV On 6/5/2010 9:09 PM, WA1NTA wrote: > > > > Does anyone have the correct settings for the K3 to work properly with the > SDR-IQ? I'm sure I've got something set wrong because when I connect the IQ > to the IF and switch output the levels seem very low, I can see signals on > 40 but they don't seem representative of what I am hearing and what the S > Meter is telling me. When I switch to 17, I can't see any activity on the > scope, but I can hear signals on the band. However when I connect the > antenna directly to the IQ and set EXT Radio back to none, I am able to > observe signals and tune them in on 17 with no problem. > > Thanks in advance. > George > WA1NTA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html