I'm performing a calibration on my K3's TXCO (5 ppm version). K3 is new/recent build, serial 44xx
K3 owner's manual, Rev. L, page 49. "Method 2 (zero-beating)" I'm using an Elecraft XG2 signal generator at roughly 14.060 MHz Procedure says to enter CW mode and tune to the specified frequency (in this case, I don't know it, as every XG2 is probably a little different) Since I don't know the exact frequency, can I spot it with the Spot function, and then proceed to the REF CAL adjustment? Or is there a catch 22 here, as the spot function may not be accurate until the TXCO is calibrated? --Andrew NV1B ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
