Hello Everyone, I booted the Max a few times and interacted with the shell. I then booted 2 Distros while the max was connected to a TV and everything seemed fine.
Shortly afterwards while attempting to boot into another distro via usb, I noticed that the tv screen failed to show the UEFI prompt. I tried rebooting several times afterwards and there was no video output and two blue LED's remained lit. After connecting to the console I observed this: When the board receives power only 1 led is lit. The console shows SecStartup then both leds light and two messages follow and nothing else happens. >>>>SecStartup >>>>MemoryInit Done >>>>BdsEntry I left the board connected in this state for about 6 hours and nothing else happened. I tried disconnecting all peripherals, only connecting usb, sd and ethernet together and singularly. I found that if I hold down SW1 for approx 5 seconds J1 led turns off but nothing happens after that. Has anyone else observed this behavior? Seems similar to this: http://lists.elinux.org/pipermail/elinux-minnowboard/Week-of-Mon-20140721/000201.html Thanks, Bryan -- Program Director Fossetcon 2014 Sept 11-13, 2014 - Orlando, FL Free and Open Source Software Expo and Technology Conference http://fossetcon.org _______________________________________________ elinux-MinnowBoard mailing list [email protected] http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
