I get this all the time too. It would be nice if it went away, I also find it annoying.
John Hendy writes: > Perhaps this is the intended behavior, but I noticed that I go to > execute a code block and get the message "C-c C-c can do nothing > useful here" if I'm not on the actual src block definition or a line > of code. If I'm on a blank line inside it, it doesn't execute. Here > was my test: > > #+begin min_config > > (add-to-list 'load-path "~/.elisp/org/lisp/") > (add-to-list 'load-path "~/.elisp/org/contrib/lisp") > > (org-babel-do-load-languages > 'org-babel-load-languages > '((R . t))) > > #+end > > Start with =emacs -Q= and then =M-x load-file RET > ~/path/to/min-config=, then use this test file: > > * heading > > #+begin_src R > ^ > x <- 1:10 > x > > #+end_src > > With the cursor at ^ it won't run. I would understand if this were in > interactive mode using =C-c '=, but the behavior of C-c C-c is to run > the whole block anyway. It seems like Org doesn't know I'm in a src > block. Since blank lines are common, I'd expect not to have to make > *sure* I'm on an actual line of code and that being anywhere in a src > block should work. > > Thoughts? > > > Thanks, > John -- Professor John Kitchin Doherty Hall A207F Department of Chemical Engineering Carnegie Mellon University Pittsburgh, PA 15213 412-268-7803 @johnkitchin http://kitchingroup.cheme.cmu.edu
