That's fantastic, much simpler than the patch!
Russell Adams <[email protected]> writes:
> Nicolas,
>
> You're right! I'd never seen -K, and its not in the manual page
> either. But clearly enough:
>
> $ dot --help
> Usage: dot [-Vv?] [-(GNE)name=val] [-(KTlso)<val>] <dot files>
>
> ...
>
> -Kv - Set layout engine to 'v' (overrides default based on command
> name)
>
> I just tried it in the example I had supplied, and it worked properly!
>
> #+BEGIN_dot dot neato.png -Tpng -Kneato
> digraph test {
>
> a -> { b c d e };
> e -> { f g h i };
>
> };
>
> #+END_dot
>
> Perhaps the patch and changes for that are pointless after all!
>
> I went back and checked the postscript / EPS issue, and it is still
> present.
>
> Thanks for that neat tip!
>
>
> On Thu, May 28, 2009 at 08:03:23PM +0200, Org Mode List wrote:
>> Hello,
>>
>> I could be wrong, but org-exp-block.el already provides support for any
>> Graphviz command since you can add the option -K as an argument to dot.
>>
>> Then again, I can have mistaken your point.
>>
>> --
>> Nicolas Goaziou
>>
>>
>>
>> _______________________________________________
>> Emacs-orgmode mailing list
>> Remember: use `Reply All' to send replies to the list.
>> [email protected]
>> http://lists.gnu.org/mailman/listinfo/emacs-orgmode
>>
>
>
> ------------------------------------------------------------------
> Russell Adams [email protected]
>
> PGP Key ID: 0x1160DCB3 http://www.adamsinfoserv.com/
>
> Fingerprint: 1723 D8CA 4280 1EC9 557F 66E8 1154 E018 1160 DCB3
>
>
> _______________________________________________
> Emacs-orgmode mailing list
> Remember: use `Reply All' to send replies to the list.
> [email protected]
> http://lists.gnu.org/mailman/listinfo/emacs-orgmode
_______________________________________________
Emacs-orgmode mailing list
Remember: use `Reply All' to send replies to the list.
[email protected]
http://lists.gnu.org/mailman/listinfo/emacs-orgmode
