Andreas, when changing the datarate from 2Mbps to 1bps and sending say a 100 byte packet, you are increasing the transmission delay from about 400 usec to 800 seconds. The packet is experiencing a large delay and you have to wait for a while (a long while) for the packet to get through before the next packet is processed.
When you toggle the rate without sending a packet, you don't see this behavior because no packet was sent with the 1bps rate. Kaushik B. Patel Adjacent Link LLC On 04/25/2017 11:44 AM, Andreas Martens1 wrote: > Hi again chaps, > > Another RF-Pipe related question; if I change the datarate on a nem at > runtime, e.g. from 2000000 to 1 (the minimum) and back again it all works > fine and my connections stay alive. but if I change the datarate to the > minimum and try to put even a single packet over the channel, then upon > resurrection to 2000000 nothing comes out the other end. > > The drop tables don't show anything being dropped, and nothing in the logs > (think CORE defaults to level 3), any caveats I might be falling into? > > Emane 1.0.1 > > cheers, > Andreas > -- > IBM Emerging Technologies, IBM United Kingdom Limited > IBM Hursley Park, Winchester, SO21 2JN > Telephone Int. 24-6833 Ext. +44 (0)1962-816833 > Lotus Notes ID : Andreas Martens1/UK/IBM Internet : [email protected] > Unless stated otherwise above: > IBM United Kingdom Limited - Registered in England and Wales with number > 741598. > Registered office: PO Box 41, North Harbour, Portsmouth, Hampshire PO6 3AU > > > > _______________________________________________ > emane-users mailing list > [email protected] > https://pf.itd.nrl.navy.mil/mailman/listinfo/emane-users > _______________________________________________ emane-users mailing list [email protected] https://pf.itd.nrl.navy.mil/mailman/listinfo/emane-users
