Hallo everyone!
I found mistake in HALUI docs (estop section) at
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Halui.
is: halui.estop.is-reset bit //pin for displaying Estop
state (emc internal) On/Off
should be: halui.estop.is-activated bit //pin for displaying
Estop state (emc internal) On/Off
There is no signal called "estop.is-reset" as described in documentation.
The real HAL signal is "estop.is-activated". Please correct this.
Thank you.
--
Best regards,
Artko_Coder
if (((*sp >= 'a' && *sp <= 'z') || (*sp >= 'A' && *sp <= 'Z')) ? (*(str - 1)
== 32 || str == start_s) && *(str + sep_len) == 32 : 1) printf("I'm only
stupid coder. :-D");
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys-and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
