Bugs item #1910452, was opened at 2008-03-09 15:40 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1910452&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: Stepconf Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Alex Joni (alex_joni) Assigned to: Jeff Epler (jepler) Summary: Stepgen-Lathe Homing HAL File BUG Initial Comment: Using stepconf to create a config for a lathe, results in a non-homing config. The ini file generated: http://www.pastebin.ca/935212 The hal file generated: http://www.pastebin.ca/935220 Ini is fine, HOME_SEQUENCE is set ok. the generated HAL file has a bad reference: net max-home-z => axis.1.home-sw-in net max-home-z => axis.1.pos-lim-sw-in those two lines should connect to axis.2.* (axis.1 is Y, which is not used on this machine). ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1910452&group_id=6744 ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
