Bugs item #3226864, was opened at 2011-03-19 14:14 Message generated for change (Settings changed) made by cradek You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=3226864&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. >Category: G-code Interpreter Group: None >Status: Closed >Resolution: Fixed Priority: 5 Private: No Submitted By: skunkwork (skunkwork) Assigned to: Chris Radek (cradek) Summary: Tool_change_at_g30 doesn't unlock rotory axis Initial Comment: commanding a tool change when Tool_change_at_g30=1 and Locking_indexer=1 in the ini - the rotory axis doesn't unlock but still tries to move the the g30 rotary axis position. This causes a following error as the axis is locked. Commanding a G30 normally acts correctly - rotary axis unlocks - rotates then locks - then subsequent axis motion is done. It would be cool if there was a mechanism to set which axis will move instead of all moving. thanks sam ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=3226864&group_id=6744 ------------------------------------------------------------------------------ Colocation vs. Managed Hosting A question and answer guide to determining the best fit for your organization - today and in the future. http://p.sf.net/sfu/internap-sfd2d _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
