I am seeing the same path here on circular arc blending... it isn't like a tolerance thing (normally it would cut the corner short.) Seems like a bug
bruno <[email protected]> wrote: >I tried reducing the G64 values, I also set G61. >I also tried running it at very slow feed rate. I increased the maximum >velocity of each axes and also the acceleration in the INI (in case it >matters in the sim) > >No change, the path goes way past the previewed path. I do not see any >difference in the path followed when I change any of the parameters above. >I tried in linuxcnc 2.5.3, 2.5.4, 2.6 pre3 sim, axis mm config. > >I do understand that it looks like the path is going out like preparing >for the following curve, so it could be some machine limit thing (and I >am crossing my fingers that it is), but G61, G64 should affect it in >this case. Really at a loss on this one. > >On 5/30/14 8:03 PM, [email protected] wrote: >>> Thanks ! >>> >Bruno >>> > >> At first glance it looks like the machine aceleration limits are not being >> followed or G64 mode issue. Have you tried G64 Px.xxx? >> >> >>> > >> Peter Wallace >> Mesa Electronics > > >------------------------------------------------------------------------------ >Time is money. Stop wasting it! Get your web API in 5 minutes. >www.restlet.com/download >http://p.sf.net/sfu/restlet >_______________________________________________ >Emc-developers mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ Time is money. Stop wasting it! Get your web API in 5 minutes. www.restlet.com/download http://p.sf.net/sfu/restlet _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
