ok this appears to be a goof on my part .. i.e dont leave remote running in the background
On 7 August 2014 12:05, David Armstrong <[email protected]> wrote: > guy's > ok finally moving on with linuxcnc and the boot.iso wheezy image > > started now to use development build > i have now found that i am recieving the failed to map shmem error as per > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?LockedMemory > > having been knocked down into using the fix as per machinekit as > previously mentioned > > however do note that on the boot.iso wheezy , and before i'm shouted at > again > that the fix as per the above is already in place > > error information is > RTAPI: ERROR: failed to map shmem > RTAPI: Locked memory limit is 64KiB, recommended at least 20480KiB. > This can cause the error 'failed to map shmem'. > For more information, see > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?LockedMemory > HAL: ERROR: could not open shared memory > halcmd: hal_init() failed: -22 > NOTE: 'rtapi' kernel module must be loaded > RTAPI: ERROR: failed to map shmem > RTAPI: Locked memory limit is 64KiB, recommended at least 20480KiB. > This can cause the error 'failed to map shmem'. > For more information, see > ------------------------------------------------------------------------------ Infragistics Professional Build stunning WinForms apps today! Reboot your WinForms applications with our WinForms controls. Build a bridge from your legacy apps to the future. http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
