Tom I have seen the same thing in Gmoccapy. I have to reload the program for the tool position changes to take effect.
------ Original Message ------ From: "Tom Easterday" <[email protected]> To: "EMC developers" <[email protected]> Sent: 2015-06-25 23:05:08 Subject: [Emc-developers] lathe tool display bug in Axis preview (2.7.0~pre6) >I have lathe tools entered in a tool table including ORIENTATION and >FRONTANGLE and BACKANGLE settings but the Axis preview does not show >these tools in their correct orientation. It is only displaying a >single triangle that points up. Is there a configuration parameter >that turns this feature on/off or is this a bug in 2.7.0~pre6? >-Tom > > >------------------------------------------------------------------------------ >Monitor 25 network devices or servers for free with OpManager! >OpManager is web-based network management software that monitors >network devices and physical & virtual servers, alerts via email & sms >for fault. Monitor 25 devices for free with no restriction. Download >now >http://ad.doubleclick.net/ddm/clk/292181274;119417398;o >_______________________________________________ >Emc-developers mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
