On Monday 25 July 2016 16:01:10 andy pugh wrote: > On 25 July 2016 at 20:33, Gene Heskett <[email protected]> wrote: > >> > (debug,31 i_mjr_R=#<_i_mjr_R>) ( s/b reasonable mm's? ) > > The problem appears to be with having two comments on the same line.
I do not recall having that problem before, but could have, theres a very faint memory rattling around back there someplace, but that did fix it, and I believe its spitting out the correct answers too. Ah, no, that taper_tot is in diameter, s/b radius, fixed. I think... Now I am closer to having enough data to run the G33.1 and get what I want. I need 4 more vars defined yet. To be the individual increments in both the x & z to be the 30 degree angle of tool advance per repeat pass, like G76 does. But I have 2 of my sons in for today & tomorrow, for a visit, so I am not able to devote full time to this just yet. Thanks Andy, I am getting there. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
