All of my lathe conversational subroutines are for use with ngcgui which is a few lines in your ini file to add. The beauty of ngcgui is you can concatenate each subroutine to make a complete part, for example I can face off the material set Z0, drill, ream, tap, turn the od, chamfer the leading edge, thread the od then part it off.
http://gnipsel.com/files/chnc/subroutines drill, face, g76, id, ntp, od, part, profile radius, radius, tap, taper id, taper od what more could you need? JT On 1/17/2017 2:10 PM, Gene Heskett wrote: > First I have heard of it, thanks for mentioning it. Sounds handy so I > looked it up. Looks usable on the mills, but I get about halfway down > the readme page and lathes aren't supported yet.:( Twould be handy. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
