On 05/29/2017 07:36 PM, Jeff Epler wrote:
A couple similar problems created at that version "3116" you
mentioned were reported and fixed
https://github.com/LinuxCNC/linuxcnc/issues/269
https://github.com/LinuxCNC/linuxcnc/issues/271
I'm sad, but it sounds like there's yet another problem lurking
there.
However, I didn't reproduce your problem here. Based on what you
described, here are the steps I followed:
* start the sample configuration configs/sim/axis/axis.ini
* click the "reload" icon in the toolbar to reload the splash part
program
I tested with v2.8.0-pre1-3128-gafe82611f, which is after version
3116 that you said you identified as leading to the problem; and at
v2.8.0-pre1-3133-g6a3b4a226 which you also mentioned.
Can you let me know the specific steps you follow to reproduce the
problem? Please reproduce it with configs/sim/axis/axis.ini if you
can, or let us know if it requires a specific configuration. It
could potentially also depend on the loaded part program.
I saw something similar in master (2.8.0~pre1-3133-g6a3b4a2263) on
Wheezy/rtai yesterday. I'll try to reproduce it tonight.
--
Sebastian Kuzminsky
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
