Hi All
I have been asked to put a very accurate and delicate lathe together. I
have to reach a repeatable resolution of sub micron values. I have found
slides and screws that will allow me to do that.
The question I have is - will I be able to control the lathe to say 0.1
micro meter with Lcnc using the Gmoccapy front end.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
