sudo make setuid ?
Put the "?" on line below to not confuse. Then adding file I hade problems to get them included first. It worked after manually adding them to some kind of Makefile but I suspect this is not the way it is supposed to be then using configure and that files should be scanned instead of adding each file manually. My knowledge about autotools and similar is however very limited. > From the forum: > > https://forum.linuxcnc.org/38-general-linuxcnc-questions/35569-rtapi-app-and-yapps2-problem-during-installation-linuxcnc-dev#121203 > > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is designed > for the especial use of mechanical geniuses, daredevils and lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
