There are no changes to existing LinuxCNC code, it is just an additional component, VCP additions and configurations.
I am not sure how to proceed, currently I have locally a master branch only. Do I copy all plasma related stuff then create a 2.8 branch from upstream then put the plasmac stuff in there and push to upstream 2.8. How do I then keep the local and upstream master and 2.8 plasmac stuff in sync as well, it will be exactly the same code for both branches. This multiple branch stuff is totally new to me and I would like to get it right. > On 6 Jul 2019, at 7:12 am, Moses McKnight <[email protected]> wrote: > > What Chris says is right - if GUI changes are just in the form of VCP and > configs and all, it is fine with me - and thanks for your work! > > Moses > > On 7/5/19 2:57 PM, Chris Morley wrote: >> The release manager has last say on what can't be added. >> Assuming your 'GUI' changes are VCP changes (not say AXIS changes) , then it >> sounds fine to add. >> plasmac is a stand alone component so is fine to add. >> If you don't get a negative response from Moses soon, I think you can safely >> assume it's ok. >> (And since 2.8 isn't released yet we actually could back out code ) >> Chris M >> ________________________________ >> From: Phillip Carter <[email protected]> >> Sent: July 5, 2019 4:25 AM >> To: linuxcnc-developers >> Subject: [Emc-developers] 2.8 plasmac >> I have tested the plasmac configurations on 2.8 and they appear to work ok >> with the only proviso that the reverse run feature is not supported. >> I have modified the GUIs so that none of the reverse run widgets show if the >> LinuxCNC version is less than 2.9. >> Is it feasible to put plasmac in 2.8? >> If so I will then need a bit of guidance on how to do it. >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers > > -- > And as it is appointed unto men once to die, but after this the judgment: > So Christ was once offered to bear the sins of many; and unto them that look > for him shall he appear the second time without sin unto salvation. > (Hebrews 9:27-28) > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
