On 8/1/22 19:31, Jérémie Tarot wrote:
Le ven. 29 juil. 2022 à 11:30, Nicklas SB Karlsson <n...@nksb.eu> a écrit :
... "start from line" was added several years ago. The motion code
may
not be
re-executed, but the mode changes it implies are.
"start from line" may be used if tool bit break or other problem occur
to start machining at a particular point in program?
Is this a question or a text replacement proposal?
IMO, it it does not do all that, it is a bug report. The one item that
could be a showstopper
would be tool changes, but it should verify the tool in the spindle is
the correct one before
actually resuming at the selected line. I faintly recall trying this
once right after it was
announced, it did not do the spindle start so I had to kill it again
before it broke a $20 tool.
That was quite a while back and I've not tried it since. Memories do
fade, and mine is not
an exception.
Outside of problems, it is very useful when tuning a program or in every
cases you want to start running a program from somewhere else than
beginning.
Explanation of its behavior should be kept and may be even improved
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/>
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
