Hi Scott:
There is no requirement that "ratings label" data be
provided on a single label or in a specific location.
You have already mentioned that specific data must be
located near the device, i.e., input ratings near the
power input, fuse ratings and fuse replacement warning
near the fuse.
FCC data must be located on the OUTSIDE of the unit,
not under an operator panel. You might verify the
FCC location requirements since you say the label is
"buried."
At a former employer, the model and serial numbers
were marked on the front of the unit. The input ratings,
fuse ratings, and certification marks were all on
separate labels or silkscreen.
Best regards,
Rich
-------------------------------------------------------------
Richard Nute Product Safety Engineer
Hewlett-Packard Company Product Regulations Group
AiO Division Tel : +1 619 655 3329
16399 West Bernardo Drive FAX : +1 619 655 4979
San Diego, California 92127 e-mail: ri...@sdd.hp.com
-------------------------------------------------------------
---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to majord...@ieee.org
with the single line: "unsubscribe emc-pstc" (without the
quotes). For help, send mail to ed.pr...@cubic.com,
j...@gwmail.monarch.com, ri...@sdd.hp.com, or
roger.volgst...@compaq.com (the list administrators).