Greetings Israel,

A standard that we use is EN 1012-1 Compressors and Vacuum Pumps - Safety
Requirements. Depending on the size of the equipment, the Pressure Directive
or Pressure Equipment Directive may also apply. 

Regards,

Ray Russell

ray_russ...@gastmfg.com


-----Original Message-----
From: Israel Yeshurun [mailto:israel_yeshu...@stcl.scitex.com]
Sent: Monday, November 22, 1999 2:25 AM
To: 'emc-p...@ieee.org'
Subject: FW: Compressed Air. Pneumatics, Safety requirements





> -----Original Message-----
> From: Israel Yeshurun
> Subject:      Compressed Air. Pneumatics,  Safety requirements
> 
> 
>        Dear Group Members,
> 
>        I would appreciate comments to the following:
> 
>              General:  In some equipment, Compressed Air is used to
> energize mechanical parts (in addition to electrical power used in the
> equipment)  safety Interlocking of those mechanical parts, can be
> performed by draining of the pressured air or by equalizing air pressure
> on both sides of the operating pistons, or by ??  The compressed air can
> be supplied from outside of the machine or be produced inside the machine
> by intended internal air compressor.    This may rise the following
> questions: 
> 
>        1)  For Low Voltage Directive Equipment, utilizing compressed air,
> are there any specific Safety requirements?  I looked in UL1950, EN60950
> but could not find such.
> 
>        2)  Regarding Machinery Directive products:   Are there specific
> requirements?  intended standards ?
> 
>       Any response will be appreciated,  
>      
>                                    Regards,      Israel Yeshurun,
> Compliance Engineer.           

---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to majord...@ieee.org
with the single line: "unsubscribe emc-pstc" (without the
quotes).  For help, send mail to ed.pr...@cubic.com,
jim_bac...@monarch.com, ri...@sdd.hp.com, or
roger.volgst...@compaq.com (the list administrators).


---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to majord...@ieee.org
with the single line: "unsubscribe emc-pstc" (without the
quotes).  For help, send mail to ed.pr...@cubic.com,
jim_bac...@monarch.com, ri...@sdd.hp.com, or
roger.volgst...@compaq.com (the list administrators).

Reply via email to