Group, Has anyone had any experience of problems with energy hazards on modular products and may be able to give some advice. The problem is that some of our equipment uses the compact PCI standard for interconnection. One of the main problems with the compact PCI standard is that it uses male connectors on the backplane card. This becomes a big problem when there is a bank of redundant power supplies capable of supplying over 240VA
The product is modular and therefore a customer can hot-plug cards. When all cards are in place they have current limiting on board and there is no access to the backplane therefore there is no problem, however they are removable without a tool and because the system is modular you never know how many slots will be used. EN60950 clearly states that 'there shall be no energy hazards in the user accessable areas' and this is quite clearly the case so how do other manufacturers of IT equipment with compact PCI busses and large power supplies get over this problem? Do other people screw their boxes shut, screw their cards in, designate the equipment for use only in a restricted access area, or use another method of protection from the hazard. I know the possible solutions but I am looking for feedback as to how some other people have overcome this and what method they have used. Any information anyone can give me would be greatly appreciated. Regards, Duncan. --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to majord...@ieee.org with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to ed.pr...@cubic.com, jim_bac...@monarch.com, ri...@sdd.hp.com, or roger.volgst...@compaq.com (the list administrators).