Obviously, I was not clear. This is an unintentional radiator. The rf signal
is radiated internally, but any external emissions are unintentional.
Richard Woods
----------
From: Helge Knudsen [SMTP:h...@jyske-emc.com]
Sent: Thursday, November 16, 2000 5:35 AM
To: emc-p...@majordomo.ieee.org; wo...@sensormatic.com
Subject: Vedr.: ITE Emissions above 1 GHz
Hello Richard,
Is the device a "blue tooth" using wireless radiation to communicate with
other devices, if yes the device is a subjet for the R&TTE directive.
You may use the ETSI standards:
EN 301 489-3 V1.2.1 (2000-08)
Electromagnetic compatibility and Radio spectrum Matters (ERM);
ElectroMagnetic Compatibility (EMC) standard for radio equipment and
services;
Part 3: Specific conditions for Short-Range Devices (SRD) operating on
frequencies between 9 kHz and 40 GHz
and
EN 300 440-2 V1.1.1 (2000-07)
Electromagnetic compatibility and Radio spectrum Matters (ERM);
Short range devices;
Radio equipment to be used in the 1 GHz to 40 GHz frequency range;
Part 2: Harmonized EN under article 3.2 of the R&TTE Directive
Those standards may be downloaded free of charge from www.etsi.org.
NOTE:They are not harmonized yet!
If it not is used for wireless communication then the EN 55022 still shall
be used for showing complience with the EMC Directive.
Best regards
Helge Knudsen
Delta
Electronics Testing, EMC
Venlighedsvej 4, DK-2970 Hoersholm
Telephone : +45 45 86 77 22
Fax : +45 45 86 58 98
>>> <wo...@sensormatic.com> 15-11-00 22:10 >>>
I have an Information Technology device that intentionally generates and
uses 2.45 GHz signals. EN55022 does not provide limits above 1 GHz. Is there
another harmonized EN that can be applied for spurious emissions above 1
GHz? If not, will this product have to be submitted to a Competent Body?
Richard Woods
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
majord...@ieee.org
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: jim_bac...@mail.monarch.com
Michael Garretson: pstc_ad...@garretson.org
For policy questions, send mail to:
Richard Nute: ri...@ieee.org
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
majord...@ieee.org
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: jim_bac...@mail.monarch.com
Michael Garretson: pstc_ad...@garretson.org
For policy questions, send mail to:
Richard Nute: ri...@ieee.org
