I'm sure there are products on the market just for this purpose. But I would be concerned about my design if pass/fail depended upon how clean the mating surfaces are. A component substitution or some other ECO to the product down the line could put the product over the limit. Refer to the thread on test margins.
John Juhasz Fiber Options Bohemia, NY -----Original Message----- From: David Heald [mailto:davehe...@mediaone.net] Sent: Thursday, February 28, 2002 2:44 PM To: emc-p...@majordomo.ieee.org Subject: Pencil erasers for pre-EMI cleaning? All, I'm preparing for an emissions test and I had started cleaning some of my chassis mating surfaces with a pen/pencil eraser then alcohol to ensure the surface to surface contact was good. A friend then told me that using an eraser would also remove the anti-corrosive coating that was on the metal (Thanks Paul!). So I would end up with a very short term benefit, then rust. What I am trying to determine is if maybe light rubbing with a pencil eraser might only remove surface contaminants and leave the metal and coatings intact. (the pencil eraser is much less abrasive than the pen side) So the real question is... Does anyone have direct good or bad experience with the aftereffects of using a pencil eraser to clean mating edges (card faceplates in a telco box for example)? I have both steel and aluminum surfaces to worry about so info for either type is welcome. (and don't worry the different metal types are not adjacent). Any feedback would be greatly appreciated as the system is really dirty right now. Thanks and Best Regards, Dave Heald ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@mediaone.net For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@mediaone.net For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"