Since you can buy a compliant gun for a few thousand dollars (used, demos, etc....), why would you want to spend at least that much in time and materials to get something close??
Mike Hopkins Thermo Electron michael.hopk...@thermo.com From: LEUNG YAT WAH DEREK [mailto:ywle...@vtc.edu.hk] Sent: Thursday, May 08, 2003 9:50 PM To: emc-p...@majordomo.ieee.org Subject: Design of low cost ESD gun. Can anyone provide some information about I want to make a low cost ESD gun for ESD test, the peak voltage about 4 or 8 k volt ( if it can induced + and - poloarity will be more better), the waveform just little similar to the specification, thanks. This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@attbi.com For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@attbi.com For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc