On Friday 31 August 2007 19:10, Kirk Wallace wrote: > Does anyone have an opinion on which g-codes to assign to these lathe > functions? > Collet Closer Open > Collet Closer Close > Cut-off Slide Extend > Cut-oof Slide Retract > Part Chute Extend > Part Chute Retract > Spindle High Range > Spindle Low Range > Stock Feed > Kirk Wallace
most of those are listed here http://www.machinetoolhelp.com/Applications/G-M-codes-okuma.html http://www.machinetoolhelp.com/CNC/Haas_G-M-codes.html we use Okuma lathes but the parts catcher on one of ours is different ,it was an add on for an older control and used one of the available user defined M-code I think it was M78/79 but I'm not sure (its in felt pen on the side of the control) you might use M80/81 for the cutoff slide and the stock feed will depend on the barfeed you use its usually done as a macro call ours is set up to call one macro to feed stock and branch to another to load a new bar ,feed out a little extra stock and part off the chamfered end Brian ------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
