Chris Radek wrote:
>I hope this is at least somewhat clear. It is a complex issue but
>be assured it is now fixed. If you do not want to wait for a 2.2.0
>release you could compile and run the development code. That
>procedure is documented here:
>
>
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Installing_EMC2#On_Ubuntu_5_10_and_6_06_from_source
>
>Chris
Hi Chris,
Thanks for your replay.
I tried to run Axis 2.2.0 but only a appears on screen the
"AXIS Manual Toolchanger" window, after that, if i run
Axis 2.1.7 appears : "EMC2 is still running. Restart it?"
if i say "Yes" appears "EMC2 Errors" window.
If i want run Axis 2.1.7 again, i have to re-start the system.
Others questions:
- How do i change the "tool change position" without
change the ini file?. Is there any variable to change it
in a "user entry widget" when i want?
- Will Axis-Lathe manipulate the tool wear dynamically ?
(without editing the tool table)
--
Best Regards,
JJ
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
