> > >
> > >
> > Gentlemen,
> > It was the Y axis brake. When the main power was turned on the
> > brake was released. When I turned the control on the brake was set. I
> > moved the leads to the brake from the NC contact to the NO contact and
> > voila - easy movement. WHEW!!!
> > thanks
> > Stuart
>
> Hi Stuart
>
> You'd do well to make certain that that brake is locked up until the
> drive for it is enabled. I've seen 'em drop a bit after emc starts and
> you get a following error message and the system shuts down.
>
> Rayh
>
Ray,
It drops a little. I will make sure the brake is not released
until I start the control with F2
thanks
Stuart
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
