Hi all
[I originally posted this at CNCZone, not realising that this list is
the prime organ for EMC.
Apologies in advance therefore for any breach of propriety.]
I'm looking for some guidance about the charge-pump set-up in EMC. I
have found in the set-up docs how to assign a parallel port pin to the
charge-pump, but that's all. A search on CNCZone yields a post about
setting up a torch system in which there is mention of "the 15 kHz
output" (but nothing about how to enable it) and searches of the EMC
docs (and the Sherline docs) add nothing further. My conclusion is that
I'm looking in the wrong place.
So, can anyone answer:
* Where is the charge-pump set up documentation?
* What's the charge-pump output amplitude (voltage)?
* What's the charge-pump output frequency?
* Is there anything else I need to do within EMC (other than assign
a pin to the charge-pump) in order to set up a controller which
expects a charge-pump signal?
Grateful thanks for any info.
Z
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
