Hi Stuart,
the g-code part is in src/emc/rs274ngc/*
you probably want to change interp_convert.cc:
int Interp::convert_tool_length_offset()
close to the end of the file.
Both G_43 and G_43_1 are done there, so just replicating the G_43 part for
G_43_1 should do the trick.
Regards,
Alex
----- Original Message -----
From: "Stuart Stevenson" <[EMAIL PROTECTED]>
To: "EMC2-Users-List" <Emc-users@lists.sourceforge.net>
Sent: Friday, February 29, 2008 10:51 PM
Subject: [Emc-users] tool length compensation
<snip>
> I would like to use the H number from the tool.tbl file with the
> G43.1 in the same manner as the H number with the G43. I grepped the
> directory and didn't find any reference to how the G43 and G43.1 were
> implemented. Where would I find the code to change the usage?
> thanks
> Stuart
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
