Greetings;
I've added a Rosewill dual parport card to the kubuntu box I'm running my mill
from, with intentions of adding some motors to my lathe. After I replace the
lathe with a better one, this 7x12 is a bit light in the rigidity dept., plus
its about worn out its spindle bearings I think.
Other than the lspci output, I don't think the system did anything with it
when it was rebooted after plugging in the card. I don't recognize anything
in an lsmod output.
lspci -vv:
0000:00:0a.0 Communication controller: NetMos Technology PCI 9815 Multi-I/O
Controller (rev 01)
Subsystem: LSI Logic / Symbios Logic 2P0S (2 port parallel adaptor)
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at c000 [size=8]
Region 1: I/O ports at c400 [size=8]
Region 2: I/O ports at c800 [size=8]
Region 3: I/O ports at cc00 [size=8]
Region 4: I/O ports at d000 [size=8]
Region 5: I/O ports at d400 [size=16]
How do I go about getting this card to be usable for emc, or is this card too
new for 6.06?
--
Cheers, Gene
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Cropp's Law:
The amount of work done varies inversly with the time spent in the
office.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
